Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello! I have a building where i can't run ethernet everywhere. Now i am looking into mesh. I have built a little test with two 2702I's (bridge mode) and when they are in the same room i get close to 200mbps, but when i go outside that room it drops ...
Hello! I have a vWlc (v 8.10.185.0) and some access points (2802i's and 2702i's). When clients move in the building the clients won't roam from ap to ap. If they do, the client disconnects form the wlan and then reconnects instead of roam. What is th...
Hello. I have a vWlc (8.5.182.0) and some ap's, one ap is a 2802i. The controller sets both radios of the 2802 to 5ghz when i want one 5 and one 2.4. I have turned off Flexible Radio Assignment but it dosent work. What have i missed?
Hello there! I am new to FlexConnect (Officeextend) and i am wondering how it works. If i configure flexconnect, does the access point outside LAN create a VPN tunnel to my LAN or does it just brodcast the ssid's and do SSID to VLAN mapping? Will it ...
Hello there, first post. I have a 2802I (loaded with ME) and a Aruba 2530-8g-PoE+ switch. My problem is that i can't get my ap to turn on the radio, it is flashing red, green and blue (unsuffucent power). I have tried to turn off PoE and just have Po...
No, if the AP is looking for it's wlc it will flash red and green. See below.EDIT: Removed the table and inserted an image instead. EDIT2: Realized that the table is WRONG, atleast for the 2802, if a 2802 flashes blue, red and green it needs more pow...
They were probably wrong about what the error was, when a 2802 is blinking red, green and blue it means that it doesn't get enough power (it needs poe+ but it hasn't negotiated to poe+) and therefore doesn't bring up its radios.Cisco IOS errorsRedSof...
