Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I'm noticing a few APs model AIR-AP2802I-E-K9 who are configure in Local mode, and I would like to switch them into FlexConnect mode, but via 9800 WLC GUI I do not have the option to do so. By clicking in the AP mode I only have the follow...
Hello all,
i'm facing a weird behaviour with a monitor capture session I made on my switches. I followed the guide provided by Cisco from this page:https://www.cisco.com/c/en/us/support/docs/ios-nx-os-software/ios-embedded-packet-capture/116045-pro...
Hello all,
I noticed a weird behaviour during the ntp configuration of a server into a Nexus 9K device.basically if I launch the command "ntp server test use-vrf management" it's all good and the string is visible in the running config:SWITCH(confi...
Hello all,
I'm having an issue with a couple of Cisco APs model 9115AXI where the 5Ghz Radios are UP but the operation Status is in "Down":
Also by looking the data via cli the situation is the same:
sho int dot11Radio 1Dot11Radio1 is UP, line proto...
Hi All,
I'm having a weird issue where I cannot access via CLI on the WLC 9800 using radius authentication user, while I can do so with the same user via GUI. I configured AAA servers and groups to match correctly and activated the HTTP and VTY acc...
Hello all, I wanted to update you about the capture. I managed to try it by making an ACL to permit only ICMP packets and looks it worked like that. So perhaps it is always needed to specify which kind of traffic you want to capture. Thank you all f...
Hello Maher and thank you for the post and tips. I've checked all the configuration of the monitor capture I set up and it looks ok, according also to the cisco page: https://www.cisco.com/c/en/us/support/docs/ios-nx-os-software/ios-embedded-packet-c...
