I have a nexus switch 93180YC-EX.I'm getting below warning syslog message:%TAHUSD-SLOT1-4-BUFFER_THRESHOLD_EXCEEDED: Module 1 Instance 0 Pool-group buffer 90 percent threshold is exceeded! (message repeated 1 time)When I checked the resources usage, ...

In tap and patch configuration of cisco fusion switch, tell me difference between below two commands:tap A1 A3tap output A1 A3  

I want to change TLS version in Cisco switch C2960X-48TS-L. The firmware version installed is c2960x-universalk9-mz.152-7.E9.bin.Please guide me how to check current TLS version and how to disable and enable particular TLS version.

I've heard that to make communication between two vlans possible, you need a layer 3 device.Suppose that I connect two layer 2 switches via trunk link passing two vlans 10 and 20 on it. Both switches have some devices of both vlans connected to it's ...

I want to know in what scenarios do we need to use NAT.Suppose we have two networks connected via point to point link. Can we just establish communication between those two networks via static route configuration at both ends?Or is NAT only needed to...