Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to change TLS version in Cisco switch C2960X-48TS-L. The firmware version installed is c2960x-universalk9-mz.152-7.E9.bin.Please guide me how to check current TLS version and how to disable and enable particular TLS version.
I've heard that to make communication between two vlans possible, you need a layer 3 device.Suppose that I connect two layer 2 switches via trunk link passing two vlans 10 and 20 on it. Both switches have some devices of both vlans connected to it's ...
I want to know in what scenarios do we need to use NAT.Suppose we have two networks connected via point to point link. Can we just establish communication between those two networks via static route configuration at both ends?Or is NAT only needed to...
So what I have understood is destination ip address of sent data won't be checked until it reaches layer 3 device because layer 2 device only look for mac addresses.
As an example, if I have three switches A, B, C in local area network and trunk port is created between switch A and B for all vlans and trunk port is created between switch B and switch C for all vlans, then traffic can be shared among all devices, ...
