Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I get this error message (logrotate ALERT exited abnormally)when perform LDAP in CCM5 environment.When I configured 1st time it synchronised but subsequently never did. I didn't realise untill I had to deal with new users. Can any one help p...
Hi,We had previously ISDN working fine dialing in from remote site. Since we changed the ISDN to ISDN2 it stppoed working. Could some one please tell me if there's any difference in configurations for ISDN and ISDN2. Your response will be highly appr...
Hi there,I have a situation where links are not big enough and we have to build arround 800 laptops + desktops. doing so is causing a chaos at the time when all the build traffic goes to notes server. temporary solution, i have two isdn circuits avai...
Hi Bjornarsb,I looked at it and on thing that is confising me is set command is onlly used on 700 series routers but I have 800 series router and don't know wether this command is used on that series.Cold you please help if possible.Regards,Jamil
Hi,Depends how many guest users come in, I would create a small subnet for them with restricted access and issue the static ip addresses. That will give yu control over them and easy to manage as well as easy to know that exactly what they been upto....
Raj,The ports on both ends of a Gigabit Ethernet link must have the same setting. Please visit the link below to clear your concept about why we use flow control.http://www.cisco.com/en/US/products/hw/switches/ps663/products_configuration_guide_chapt...
Hi,GLBP has a slight edge over the HSRP as long as you have the routers with compatible IOS. Following IOS are recommended.This will also help if the routers differ in capacity or links differ in bandwidth. Cisco IOS Software Release 12.2(14)S? Relea...
