Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can't get the Vlan interfaces on the FWSM to come up because I don't have a phy int to bind them to... Anyone know how to do this?Here's the relevent config for the fwsm:interface Vlan100 nameif inside security-level 100 ip address 10.254.254.203 2...
Just wondering if anyone knows if it's possible to have a Tacacs server supporting multiple networks through 2 different Nics. I.e., One network on a 10.0.0.0 segment, and an another on say a 192.168.0.0 Network (each attached seperately via Dual Nic...
Just wondering if anyone knows if it's possible to have a Tacacs server supporting multiple networks through 2 different Nics. I.e., One network on a 10.0.0.0 segment, and an another on say a 192.168.0.0 Network (each attached seperately via Dual Ni...
I have several AD users that login to Ciscoworks via Tacacs Authentication.however, they do not have the access (system administrator) that I've specified in Tacacs for Group Authentication.Users haven't been created on the Ciscoworks server, they on...
That's what I had guessed and tried to config from, but the interfaces remain down/down. I'm not sure how to bring them up without a phys connected interface that's up and attached to the vlan.I've brought an interface up on the switch side for that...
