Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
the upgrade of my standalone 3850 from iosxe 16.12.13 to 16.12.15 was going ok (install add file flash:cat3k_caa-universalk9.16.12.15.SPA.bin activate commit) until my finger slipped at the 'This operation may require a reload of the system. Do you w...
I converted my 3802i lightweight access point into an autonomous one running 8.5.182, gave it a management ip address of 10.136.32.50 and then rebooted it. but the console message gave a different ip address (same network but not the one I statically...
i'm sorry if this question sounds silly but say at a small branch location I connect port 47 on an access switch to port 1 on a core switch and then repeat with ports 48 & 1 but for some reason each connection is assigned to a different port channel....
I’m sorry for the length of this description but…. I have to replace a standalone c4507r+e (core) switch with a standalone c9407 switch at one of my company’s branch locations. So far the 9407 was powered up and connected to the 4507 via an lacp trun...
My understanding is the phone swport cannot be managed. But if it’s bad, it can prevent a pc from getting an ip address right? my company uses the 8841.
Hi Htonieto, i'm sorry, i thought i'd replied a couple of days ago. I have two conf files for 16.12.15 because the switch created one for my attempted upgrade and then i made a copy of that as part of a plan to rename it packages.conf (to overwrite t...
hi Stefan, sorry, this happened over a week ago so i forgot to mention that i tried another "install add file flash:cat3k_caa-universalk9.16.12.15.SPA.bin activate commit" after the install remove inactive and the switch shot me down. so i should try...
sorry, i finally got a chance to get back in front of the ap and did it again. i had to move this ap to another box, which basically rebooted it. but i logged the console output this time (attached txt). so the ap picked up ip 192.168.0.98. by itself...
