Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
To configure an alias for SSH access on a Cisco Catalyst 9300 switch, you need to use the ip host command. Here's the correct syntax:ip host <hostname> <ip-address>Replace <hostname> with the desired alias or hostname and <ip-address> with the corre...
This error message indicates that the SCL line on the I2C bus is stuck low, which is causing the switch to enter a recovery mode. Here are a few possible solutions to try:Check the physical connection: Ensure that all cables and connectors are proper...
If I understand correctly, you are asking what to do when you have two switches configured as primary and secondary, and you need to switch between them, but you encounter configuration conflicts when switching back to the original primary switch.In ...
Hi Thomas,It seems like you have already identified the issue with asymmetrical traffic and have configured the "l2vpn load-balancing flow src-dst-X" command to achieve some level of load balancing. However, you are still experiencing drops when tryi...
Good wishes Dhau,The behavior you are observing is a feature of the Cisco ASA firewall's password management system. When an administrator changes a user's password hash, the user is forced to change their password upon their next login. This is a se...
