Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyoneI have seen a couple of instances recently where the CUCME passwords (associated to Devices for TAPI) seem to have defaulted back to "NULL". I cannot see any reason why this has happened, and I'm not 100% sure that this has been the case (...
HiI have a 2620XM Router that is configured for H323 Calls & Faxing...I need to add the ability for it to support SIP Phone calls as well - can anyone point me in the right direction here?Thanks
Hi GuysI am having a very strange problem that I am hoping someone can help me with:I have installed CCM 4.1(3) on a laptop. I have performed a non-mcs installation hundreds of times before without any issues. During this installation, there were no ...
Hi everyoneI'm hoping somebody can help me!I am trying to perform a very simple task on my CallManager, yet for some reason I am having immense difficulties!Scenario is as follows:I had an IP Phone with a DN of 5706. This phone was de-registered and ...
Hi everyoneI use a PIX 501 as a VPN Concentrator for a few remote workers. This has been working fine, but for some reason it has become unstable over the last few weeksThe PIX becomes unstable, and cannot be pinged either internally or connected to ...
That is correct - the old/bundled Cisco Attendant Console has been End of Life for quite some time now, and has been superseded by the Cisco Unified Attendant Console portfolio that Jonathan mentioned...Its not strictly true to say that there are no ...
Hi thereabsolutely, and you guys are already an Arc Enterprise user in Plano! Let me know your email address or phone number and I'll give you a call - either bgrant@arcsolutions.com or begrant@cisco.comCheers
Are you referring to Arc Enterprise or CUEAC? This thread is relating to CUEAC?If it is Arc Enterprise, please contact Arc directly at support@arcsolutions.com, or use the forum the http://forum.arcsolutions.com
Yes - that is correct. If you need the ability to have different queues for different Operators (not shared accross all of them) - then you would need CUEAC or Arc EnterpriseCheers
Great feedback - that is the likely issue...If you need help with this, feel free to post here, contact TAC, or register for the new Arc Forum for questions on Arc and CUxAC products. Visit http://forum.arcsolutions.com to registerThanks