Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Morning All,Need to bounce an idea around if I may.... We have a client currently running CUCM 7.1.3, all servers and PRI's are located at site A. Phones at site B are registered to the cucms over a LES cct which also has a H.323 gateway regis...
Hello Forum,Been a whilst since I've been on here but could do with a pointer or two....Snag experienced on site is that the first call going into the main number (200) is ringing on the reception phone which is fine, the issue arises when the second...
Morning all,Anyone done this and could highlight the steps involved?Due to tight timeframes we intend to use the same config from the old box and simply copy this across and tidy up at a later date.We have a license upgrade cd and new PAK for 7.0 to ...
Hi,Anyone had any problems with MGCP ATA 186's configured on a HP Procurve switching infrastructure (2610's)?The network light is constantly on and the customer has to reset them every other day to get them working again. Both the ATA's and switch p...
Hi,I'm trying to configure the AAR Group and AAR CSS on a 2821 MGCP Gateway with 2 x VIC2-2BRI modules installed. Every time I try to add these parameters I get the following error message:Update failed. [422] AAR Group OR AAR Calling Search Space c...
Hi Aaron,Woods for the trees moment I think....! Of course, the IP Phones won't even be using the VG at site B so the protocol doesn't even matter. Just a simple case of amending the RP, RL, RG for those IP Phones at site B. Simples...
Hi Aaron,Apologies, the PIN dialing at site A works perfectly because as you say I'm doing a pre @ discard and then readding the 9 to send the call to the VG's at site A for PSTN break out. The Tiger billing solution records and maps the PIN's diale...
Whilst no longer bundled with either versions 7 and 8 I did hear that Attendant Console would still be supported in later versions. i.e if you have a customer running CUCM 5 or 6 and you then upgrade to 7 or 8 you can still use the AC software.
Is this a multisite deployment? If so, what codec are you using between these sites, G729 - 24kbps, G711 - 64kbps? Best practice over the WAN is to use G729. Once you've checked your Region settings check your Location settings to ensure that they...
