Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we currently deploying our N9K-C92348GC-X NXOS 10.5(2) F switches to NDFC and NDI, but the synch of telemetry config from NDFC went failed. We saw a notification said "icam not supported"...
is that mean icam mandatory to run hardware telemetry (CPU,...
Dear All Cisco Community,
we have an problem when establishing 2 sessions of telemetry as detailed below :
We Add Our SwitchNEXUS to NDFC and NDI, and then configured 2 telemetry sessionSession #1, Telemetry configured/pushed by NDI using destination...
Hello all,
Recently we upgrade our UCS C225 M6 firmware from shipped Release 4.3(4.242038) to Release 4.3(5.250030) by using HUU under this guidance from Cisco
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/sw/lomug/4-3/b_cisco-hos...
Hello All,We want to clear single client dhcp leased manually from our DHCP Server MS410, could we perform manually? instead of we wait until the leased time over or shorten the lease time period?thank you
Hello All,We are facing more than 700 Interfering APs on our AP, could it be the problem all users that used 2.4Ghz having bad quality experience like high latency and intermittent?Should we contained all the Other APs to reduce interference and impr...
we use the same vrf management to deploy these telemetry sessions.. anyway, is that means we couldn't run these multiple session due to lack of hardware capabilities ?
is that mean, for now we need to perform downgrade simultaneously to the previous version 4.34 by using HUU by check all part (BIOS, CIMC, VIC) downgraded together ?
at the moment we could solve the problem by using these configuration below :Management IP Old MS410 Switch : 192.168.1.2/24Management IP New MS410 Switch : 192.168.1.4/24SVI Stack Switch as p2p to FW : 192.168.1.3/24IP p2p on FW side : 192.168.1.1/2...
at the moment we could solve the problem by using these configuration below :Management IP Old MS410 Switch : 192.168.1.2/24Management IP New MS410 Switch : 192.168.1.4/24SVI Stack Switch as p2p to FW : 192.168.1.3/24IP p2p on FW side : 192.168.1.1/2...
