Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello people, I am trying to span layer 2 using mpls, on Cisco ASR920. I have a vlan (vlan 400) coming in on an interface (g0/22) on a Cisco ASR920, and i want to span it over to another ASR920 as layer 2. But............ there are 2 ways i can do th...
Hello and Merry Christmas, I'm trying to decide on which pair or set of switches would be best? I have the following requirements:I need approximately 150 * 100M portsApproximately 150 * 1G portsAnd a mix of both copper and fibre. Could someone sug...
Hi All,I'd just like to get your opinion on the a weird set up.I have site A and site B which each have a ASA each. I create 2 VPNS from site A to site B. My questions is. which VPN would be used for sending traffic? What would be the default behavio...
Hi Community,I am trying to figure out which protocol to use on a flat layer 2 VPLS. We have a flat layer 2 to connect 10 offices and some other point to point links to connect to other offices. We currently use EIGRP but going forward we want to con...
Hi All, I'm trying to figure out how I can do QoS on a 6500 and police traffic based on an IP access-list. I want to define an access-list which specifies the traffic based on soure and destination IP addresses. I then plan to use a class map to matc...
thank you, I dont plan to use a third site.so i could use either. I guess the simplest config would be the best.... any suggestions on which is the simplest and most reliable.. ie not likely to be affected by bugs?
Hi Jouni,Thanks for your reply, Let me tweak the question a little. What if we had 1 ASA at site A, and 2 ASAs at site B. We woud then create 2 VPN tunnels:tunnel1: Site A ASA1 to Site B ASA1tunnel2: Site A ASA1 to Site B ASA2So the problem i...
Hi Vaibhava, Many thanks for your reply, I have been thinking about your suggestions all week. I realized that OSPF or EIGRP would be best to take advantage of the layer 2 any to any feature of VPLS. However, this VPLS structure I am using may be rep...
Hi Leo, Thanks for your reply. I am using policy on a gig interface so it should work as I am only policing. However, I'm doing this in a hiearchical qos policy. The commands were taken without problems. Can you tell if it is actually working from th...
