Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're seeing syslog messages generated from a couple of Nexus 5ks that we can't relate to anything. All the devices authenticates using TACACS and the syslog messages appear randomly. Can someone explain this behavior?"AUTHPRIV 2 SYSTEM_MSG ...
Hi,I'm trying to configure policing and/or shaping on a setup of 2 x ASA 5505 Sec Plus. The units are placed in office A and office B and each have a ISP connection to the internet and a leased line with a capacity of 4/4 Mbit/s for interoffice commu...
I'm currently in the process of redesigning our corporate network to accommodate the change from standalone servers to a VMware/Equallogic enviroment. We'll be using iSCSI to connect the vm's to the SAN. My question is as following. How should a prop...
Is there reason why WS-C3560C-8PC-S and WS-C3560C-12PC-S is not supported in Cisco Network Assistent? According to the data sheets for these switches CNA should be supported. I saw another forum post stating that the Gigabit versions has been added t...
Hi,I'm pulling my hair in order to make a couple of SF300 switches to work properly with a C2960S-48TS-L that acts as core switch/basic router. I can't seem to figure out how to assign VLANs correctly in trunk and access mode on the SF300. The 2960S ...
What kind of SAN are you planning to install?I would keep ISCSI and LAN traffic physical seperated unless you're using Nexus switches. Why do you want the ISCSI network reachable from networks outside the server network? If your only interested in ma...
A long time since the question was posted but one thing struck me when rereading it. Have you verified that the phone can reach the tftp server at all? If you don't see tftp request in the debug one should suspect that it can't communicate with the t...
I too had the same problem. We were a bit confused about the statement that since sw release 7.0.230 this should be included. Your post shortened our troubleshooting quite a bit Best regardsMarkus
I finally got shaping to work on the desired interface. I had the commands right the whole time but when I tried to configure a "class class-default" under a new "policy-map" I pressed TAB to call up the command instead of writing it. This actually s...
