Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have some polycom 335 sip phones that are registered with CUCM. They are able to call an auto attendent but after the call is connected and you are asked to select an option the digits don't seem to register correctly. All the other devices in the ...
I have some Polycom 335 sip phones that do not seem to pass their dtmf tones correctly when the digits are press for an AA. All of my other devices including a sip ata that is trunked to CM are able to talk with the AA just fine. I can't seem to loca...
Has anyone connected a SPA8000 with CUCM? I'm a little confused as to how you would setup the numbers, and what to do about only having one MAC address.If anyone has any details about how to get these two to work together would be great (the more det...
note:I had at one point these phones register, but had to change numbers and that is when things have gotten weird.So I am trying to get a Polycom 335 3rd party sip phone to register with CUCM.I have gotten to the point where I have deleted all other...
I am trying to set up a vg224 to work with CUCM.I was following a config1. enable2. configure terminal3. stcapp ccm-group group-id4. stcapp5. stcapp feature access-code6. stcapp feature speed-dial7. voice-port slot-number/port8. timeouts initial seco...
Alright, I was able to get line 1 connected, but I'm not sure how I could get the other 7.To get the 1st line, I created and End User with the sip user/passThen I created a 3rd party sip phone and used the MAC address of the SPA8000Finally I added my...
Alright, I was able to get line 1 connected, but I'm not sure how I could get the other 7.To get the 1st line, I created and End User with the sip user/passThen I created a 3rd party sip phone and used the MAC address of the SPA8000Finally I added my...
I am not sure what exactly fixed it... but it works now.I reset CUCM completly turned it off and on again, and I reset the Polycom phones to their default settings and reconfigured them.I'm guessing there was some stray setting in the Polycom phones ...
