About pspy

pspy · 03-26-2008

Hello, I've done some testing with an RPS 2300 and a C2950G-24 When I disconnect the AC power cable of the 2950 "simulating a power problem", the RPS takes over. When the AC power comes back, the 2950 doesn't switch back to the AC source.The command...

pspy · 03-20-2007

Hello, I need to change the hub's public IP-address. The only way to reach the spokes is through the tunnel.Action plan was to change the nhrp maps in the spokes first, then at last to change the hubs public IP. This didn't worked, because the tunnel...

pspy · 02-06-2005

Hi all,I'm trying to implement a hub and spoke "wheel" with a PIX515E as hub and Cisco831 routers as spokes. Unfortunatley the PIX has no public internet address; it's one-to-one static nat-ed to a public address. The spokes are behind PAT-devices.To...

pspy · 10-29-2003

One of two 6513's increases the counter on ALL RJ45 ports of a 48-Port RJ45 FE Module, no matter if a cable is connected or not. About 20'000 - 30'000 drops per second ! VLAN membership independent. Other modules like GBIC-Blades are well, but not th...

pspy · 04-02-2003

To build a standard offering for small office clients, I have the following questions:1. Can a Cisco 826/8xx Router act as a "VPN-server" for 2-3 PC's with Cisco VPN Client installed ? IP FW / IPSEC 3DES IOS installed ? 2. Can a Cisco8xx also be a Ea...

pspy · 04-02-2008

Hi CollinThank you.Yes, that's correct. Unfortunatley power cycling the RPS restarts the attached 2950! Also power cycling the 2950 recovers from that situation. Sounds like the RPS is not-so-redundant in terms of 2950.Does there exist any documentat...

pspy · 03-23-2007

Hi Gilbertthanks a lot for your suggestion. I tried it, but it didn't work. Creating a second tunnel-ifc was ok, but the IP address must be in another range. Also the original tunnel crashed after applying the crypto rules.I found some new commands o...

pspy · 03-10-2005

Thanks for your response. In the mean time, I was on site and to my own surprise and against all expectations, a migration of the userDB v2.3 >> v3.3 was successful! I tried several ways and finally it was the v2.3 dump.txt file, which I imported to ...

pspy · 03-08-2005

Hi allhave you got an answer for this? We have a similar situation here, upgrading from v2.3 to v3.3 and trying to migrate the DB. But we're not sure if it can be done.Thanks and regards Peter

Member Since	‎04-02-2003 01:31 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	9

User Statistics

User Activity

No RPS resume after AC failure

DMVPN tunnels stay up

PIX to IOS L2L with one side behind PAT-device

Rapidly increasing "Total output drops" counter on a 6513

Establish a VPN from VPN-Client to Cisco 826

Re: No RPS resume after AC failure

Re: DMVPN tunnels stay up

Re: Upgrading Cisco Secure ACS 2.6

Re: Upgrading Cisco Secure ACS 2.6