While porting over a config from a WS-C2960XR-24TS-I: Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.2(2)E7, RELEASE SOFTWARE (fc3)To a C9200-24T: Cisco IOS Software [Cupertino], Catalyst L3 Switch Software (CAT9K_LI...
Looking at this: Cisco UCS C220 M6 Server Installation and Service Guide https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/hw/c220m6/install/c220m6/C220M5_chapter_00.htmlParticularly, this section's reference highlighted in blue:Mod...
Is there some trick to getting auto-negotiation working on a SFP-10G-T-X connected to a 'UCS VIC 1467' (UCSC-M-V25-04) MLOM adapter?The compatibility matrix claims a few supported speeds, but we've been unable to connect to a couple different network...
I don't know if that's true, because if I connect the C9200 port 7 to an old 10/100 NetGear switch, it goes 100Mb/s:Switch#show interfaces GigabitEthernet 1/0/7GigabitEthernet1/0/7 is up, line protocol is up (connected)Hardware is Gigabit Ethernet, a...
So we're connecting from 10G SFP on the server MLOM to the first port on a C9200, and hoping to get sync:Switch#show interfaces GigabitEthernet 1/0/1 capabilitiesGigabitEthernet1/0/1Model: C9200CX-12T-2X2GType: 10/100/1000BaseTXSpeed: 10,100,1000,aut...