Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently deployed a few RoomKit EQs and are having an issue with the sharing content using the USB-C connection. Using the USB-C cable connected to a laptop, I am able to utilize the cameras and mics in the room that are connected to the Codec EQ, ...
I am conducting a large AV project using room kit Pro with (1) quad cam and (1) P60. Everything is working great with that setup, I am using the the classroom room type in my configuration where speaker track is working with the quad cam and presente...
I have a full Meraki stack in a higher-ed environment, (2) MX 450 security appliance, (100+) MS 250 switches, and (500+) MR 33 42 and 84 wireless access points. Over the past few days, i have been complaints from users about latency and slow Internet...
I am starting a project to implement splash pages for my SSIDs using Splash Access. I have (4) networks in my environment that contain wireless, security (MX), and switches. It was suggested that I use templates to configure my SSIDs so that it can b...
I have a MX450, setup in HA pair, in a campus environment that is connected to a 1GB Internet connection. The MX450 is used exclusively for the student residential housing units, approximately (10) buildings with about 10,000 connected devices. In ad...
Yes, I have the 1st P60 working with PresenterTrack enabled to capture the presenter in the front of the room, but can the 2nd P60 be configured with SpeakerTrack/PresenterTrack to capture the audience?
I think I found the fix? Sounds too simple, but a reboot of the MX450. Since the reboot on Friday, approximately 48 hours ago, device utilization is about 15% with 5800 clients connected. Keeping an eye on it…
Thanks, I've reviewed this documentation, the thing that worries me is the following:Note: When binding an existing network to a template, its current configuration will be lost and it will begin using the template configuration.I am trying to avoid ...
Yes. I have a 5Gb Internet circuit that I am receiving from the ISP that needs to be connected to MX450. I need to be able to keep all the security features enabled on the MX450.
