Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Most of the management software that I've seen seems to gather information about a device by polling the device and grabbing the first interface in the ifindex list.I would like to -force- a selected interface to ifindex 1. Is there a command that w...
After many years of trying to do this we finally switched to a third party box to do QOS through our network since Cisco didn't seem to have an solution to do this.Is there any way, for the purposes of applying some form of QOS (LLQ or GTS/WFQ) for a...
I've read your message a half dozen times, and I'm still not entirely clear what your attempting to do or where you're attempting to control the traffic or how many routers you have.But I did see one item that I think you're mistaken on. You can sha...
I can say that we haven't seen an issue with GRE being a limiter for GRE/IPSec. An 831 can only do 10 IPSec connections concurrently, and you can run 20 GRE tunnels at the same time from that 831.In other words, I don't believe there is a direct con...
Since no one has answered yet, I'll give you the practical answer.You'll have issues with IPSec and static routing. "DMVPN" itself probably wouldn't have an issue, but it would depend on IPSec and routing to work.It is easier, by far, to put in a se...
show crypto ipsec sa interface Multilink1 detailinterface Multilink1 ip route-cache flow endshow ip cache Multilink1 flow- Verify that your test traffic is not going around the tunnel.- What version of IOS are you on? (We've seen some misreporting o...
