Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI want to set one of my switch's port in 2 different VLAN.I already read that we can put a port in multiple VLAN with the command : switchport mode multi. Then I think, you can specify which vlan is allowed.But I want to know how can I do this kin...
Hi allI want to know if it's possible (see attachment for detail) to manage multiple subnet within a Layer 3 switch (3750) through a ASA5520 with 802.1Q tagging.Refering to jpg file; the SQL and ACS subnet are only define in the layer 3 switch The D...
Hi allI have 3825 router with 12.3(14)T7 IOS and I want to know if it's possible for the router to send snmp trap when he lost his association with a NTP server ?Thank you very much
Hi allI have some problem to establish a TS session between 2 desktops. I have 2 C831 with IPSec VPN between them and everything work fine. But if I take 2 C871 with the same settings, the session is not establish properly.Here's my interface setti...
HiWe are to plan a migration from DMVPN Phase 2 12.3(11) to a DMVPN Phase 3 architecture (about 300 spokes).Does someone have experience any issues with the following IOS version in a DMVPN Phase 3 architecture ?12.4 (11) or 12.4 (15).Thank you very ...
This is why I want to find a file (I remember that we have one with VMS) that have all the possible prompt that a device can print out, and a default answer associated to it.I'll probably run 2 diff job like you said.Thanks for your help
But if I want to scedule a reload on routers that have unsaved modifications and other that haven't.The router that have unsaved modifications will prompt me this :System configuration has been modified. Save? [yes/no]:thenProceed with reload? [confi...
ThanksThe routing was my second thinking. I can't put the port in a trunking mode because it's a node port and must be an access mode port.I'll create another subnet for that node and it will talk with the nodes that are in the 2 vlan.Thank to both ...
Do I need to put subinterface on my inside interface too or just on my DMZ port ?Does the ASA subinterfaces are trunking 802.1q by defaut ?Thank you very much
