Gui question.Someone installed 190 WAPs and a couple Controllers without documenting anything because they said it's all in the web interface. The WAPs aren't physically visibile. I've been unplugging some WAPs to see where they list as "down" but I ...
Hi there,
We're running CUCM with NTP pointing to an old (removed) domain controller. I'd like to edit CUCM's IP server address but I don't seem to be getting the syntax correct. I've been reading I should be able to type "utils ntp server add x.x....
Hey there,I was making some (deleting stuff)changes to a working voice config. Then I decided to load my config that I KNOW works. the router gave me a warning that mgcp was still running but I went ahead anyway. I then reloaded and now it doesn't gi...
Hey there,I can't figure out VPN so I was wondering if, as a backup plan, I could just let someone through my IOS firewall and NAT.I just need to let them browse the GUI of a handfull of addresses.I don't even know where to start.
Man o man I'm getting burnt out over all this.I wiped out my VPN config to start from scratch. When I entered:no crypto pki certificate chain TP-self-signed-3884018817It asked:Are you sure (y/n) Y - but I wasn't sure.It replied with"be sure to ask yo...
Thanks so much for the reply.Ver. 17.9.4aYes, when a WAP indeed goes down it ends up in the Not Joined list. Unfortunately, it just shows stats and I can no longer inspect its configuration. In it's configuration, for Location, I've been configuring ...
class-map match-all crewdata match access-group name crewdataclass-map match-all ownerdata match access-group name ownerdata!!policy-map QoS class ownerdata bandwidth remaining percent 99 class crewdata bandwidth remaining percent 1!! !!!crypto ips...
Here's what my sh access-list comes up withStandard IP access list 1 10 permit 192.168.0.0 wildcard bits 0.0.255.255 (13449 matches)Extended IP access list crewdata 10 permit ip 192.168.54.0 0.0.0.255 any 20 permit ip any 192.168.54.0 0.0.0.255...
I have now moved it to the inside int of my 2801 router but it didn't change anything.I also thought I would try to change it to an input policy but it won't even let me do that.It gives me the "CBWFQ is only allowed outbound" error.
