Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For an IP conversation that is passed through 2 routers....and packets are captured at the output of each router at the ports the IP conversation is routed to.....would each side of the router packet capture carry the same packets or conversation pac...
Does RSVP determine what incremental delay to specify for each router so a total end to end delay is not exceeded? Or as an example, if the RSVP protocol determined there are 5 routers in a path and its end to end (Sender to Receiver) delay requireme...
I cant seem to view a Syslog with a Device Mgr. I have one router connected to a PC with Device Mgr software installed. I think I set all the enables for Syslog. I set the IP address for the syslog to report to the PC that Device Mgr is installed...
How can I ping point to point, or ethernet to ethernet when there is no IP address assigned? Is that possible? I tried using a MAC address with Ping but that did not work. In this case its a PC to a ethernet to 100BaseF (fiber) conversion and I w...
I am measuring re-convergence times between LAN routers of between 1-5 seconds. Can the router settings be tweeked to improve that time?Configuration is:2 routers in cluster configuration on west side (R1, R2) to provide redundant links.1 router on ...
Understood. Ill have to add another Ip configurable device on the other end. How do people test ethernet. They must do it without having to have TCP/IP?
I searched and found this thread and thought maybe those listed might be able to help. How can one configure a network to have redundant links to a single NIC or MAC address? This would be called fault tolerant so that if one link failed the other l...
