Hi All,
I have an EZ VPN setup where the client has sucessufully connected to the client. However, when the client pings the device behind the server, I do not see any response.
The device behind the server is responding. I could also see decaps/...
Hello All, I have a site to site VPN setup and no explicit ACL to allow OUTSIDE to INSIDE traffic. As per my understanding the traffic should not flow from site 1 to site 2. However, this is not the case.The traffic from site 1 is reaching site 2. Ca...
Hi All,
I am trying to redistribute specific BGP and connected routes into EIGRP using route-map however it does not work. When I try to simply redistribute all BGP routes without any route-map then everything works fine.
The config of the device is...
Hi All,
I have got a topology as shown below:
R16---IBGP----R18
| |
EBGP EBGP
| |
R23--IBGP-----R20
Here R20 is learning a route 192.168.0.0/16 which is generated by R16. The rout...
Hi All,
I have a topology and testing all possible routing in it. I am currently stuck in a redistribution scenario explained as below:
The Blue side is EIGRP and the Yellow side is OSPF. Both these protocol are running in a single AS.
Now I want ...
I believe I am not clear enough with my query. The IPSEC tunnel is up and running. I am able to ping from LAN 1 to LAN 2. My question is when the traffic reaches from LAN 1 to LAN 2, which is OUTSIDE to INSIDE then why is the traffic allowed without ...
