Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having a hard time figuring out what I am missing here. But essentially I have a cisco 2960x switch with the SDM profile for routing enabled and IProuting enabled in the config. I have 2 Vlans (vlan 2 network computers are on 192.168.2.x 255.255...
Hi All,I have been trying to setup a port channel with LACP to a netgear CAX80 which is functioning as a Router/DHCP server. Everything is untagged. The Port Channel looks like it works ok and everything comes up but I am unable to access the mgmt ad...
Hi All,I am having an issue where on my SG300 with POE+ it doesn't seem like its giving full POE power to my Cisco AP3702. If I look on the WLC 2504 there is no text box showing POE statistics like I would see if I connected the AP directly to the co...
192.168.1.1 does not have capability to add route. This makes complete sense now! thank you all. Basically since the switch can't do NAT i would have to add a reverse route on 192.168.1.1 otherwise it won't ever work the way I am trying, Or as sugges...
That was my thought was to do unidirectional routing via static routes. having IP Route 0.0.0.0 0.0.0.0 192.168.1.1 on the 2960x switch I would think would get me the ability to ping 192.168.1.1 from VLAN 2 on the 2960 switch correct? But that doesn'...
VLAN 2 is only on the switch 192.168.1.4 (the cisco 2960x switch). The router/gateway (192.168.1.1) the consumer device has no vlans on it it is attached to the interface g1/0/23 in access mode vlan 10 to the cisco 2960x. I am trying to get the cisco...
Arp table below with computer on vlan 2. The rest of the devices on vlan 10 are connected to another switch attached to the router / gateway. The gateway/router is just a consumer router/gateway with IP address of 192.168.1.1 (not vlan capable). I ma...
