Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,Would you please help with this logs:Aug 20 11:49:02.242: NTP Core (NOTICE): ntp_receive: dropping message: unsynch.Aug 20 11:49:19.170: NTP Core (NOTICE): ntp_receive: dropping message: unsynch.The device is a NTP master for the network. Is ...
Dear All,Would you please tell me what is the limit of the remote access VPN users connected simultaneously on a 2800 router with Advanced IP Services IOS?Thanks in advance!
Hi Guys,Would you please tell me if 2801 can support more then 30 simultaneous calls (which is stated as a limit in the DSP calculator). For sure you can add 2 x PVDM-64, which should make the router to support more then 120 simultaneous calls.Thanks...
Hi,Would you please tell me if CUBE licenses are needed for a voice gateway between TDM and VoIP?I checked that CUBE is needed for the following:â H.323 to H.323 (including Cisco Unified Communications Manager) â H.323 to SIP (including Cisco Uni...
Dear All,Please provide some info about SPAN capabilities and limitations of ISR EtherSwitch Service Modules (NME-XD-48ES-2S-P, NME-X-23ES-1G-P, ...).For example, I was able to find this document:http://www.cisco.com/en/US/prod/collateral/routers/ps2...
My idea was the following:All TCP traffic between hosts in sites - try not to do fragmentation at all (neither IPSEC nor GRE)All UDP or other traffic - if hosts use large MTUs, hosts should use PMTUD to adjust the correct MTURegards,Mladen
Thanks for the response.May be I misinterpreted the document:http://www.cisco.com/en/US/tech/tk827/tk369/technologies_white_paper09186a00800d6979.shtml ?Regards,Mladen
So,For SSL VPN it is clear, but for Easy VPN the only limitation should be the IPSec VPN throughput: The Cisco 2800 Series Module (AIM-VPN/SSL-2) can provide hardware-based IPSec encryption services of 30 and 90 Mbps in the Cisco 2801, 35 and 100 Mbp...
Thanks for the response, guys!Would you please point to me the Cisco document, that states which configuration is supported on 2801 and 2811 (other then the DSP calculator).Regards,
Thanks for the answer. But it is an extract from a documentation, which I have already read.I have posted a concrete question, after reading lots of documents.Regards