Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,We are using IDSM-2 module in cisco 6509 chassis.I believe that only the default signatures were enabled on it at the time of implmentation.Now when I monitorit (I use cisco IDM as the GUI to access IDSM-2) like after 6 months I could find th...
Could Some body please tell me how can I route my webtraffic through the Bluecoat proxy server.I have given a default route on the Core switch topoint all traffic (0.0.0.0) to the external firewall and also the external firewall is directly conected ...
Hi Guys,Here is the scenario.I have three branches and for each branch I have created separate AA .But how do I create seperate After-Office-Hours (4 pm - 8 am) message for all the three branches using schedules and Unity connection Call Routing rule...
Hi,I have two 6509 Core switches in my Datacenter and is running HSRP between them.It has got a couple of Vlans and Vlan interfaces created on it.It also has OSPF created for the same Vlans on the CORE switch .Can somebody explain to me what is the n...
I would require some assistanace from you.I have a Call Manager 6.0 and Unity Connection 2.1 and a DID range of 47XX range .What I want is to create is an Auto Attendant System .Once outside caller from PSTN calls our company it should go to auto att...
No , OSPF is not configured on the FWSM .My doubt is something like this what will happen if OSPF was not configured since I could see lot of static routes on the CORE Switch.Thanks for you advice.
What do you mean by that ? The Configuration is given below.Please verify.vlan 311name FWSM_ADM_OUTvlan 312name FWSM_ADM_INvlan 321name FWSM_DC_OUTvlan 322name FWSM_DC_INinterface Loopback0 ip address 172.10.250.1 255.255.255.255 no ip redirects no i...
I bet it is a physical layer problem.I get this error most of the time and I change the network cable between the IP phone and Patch panel (or to the switch incase if you don't have a patch panel) and it works.
Ok everything is working fine and it is transferring calls based on caller inputs.Now i have two issues1.when I dial the DID number of the CTI route point i can't hear any ring tones.2.I don't know which option to select under System call handler > e...
