Hello everyone,
I configured ip http secure server to test https access to my router.
I can access from the web browser, but when I try to telnet from the router to interfaces within it the session does not close. I would like to know if anyone has ...
Hello All,
A monitor capture has been configured on Cisco 9400.
I have an external device with 2 interfaces (main/backup) on this Switch, when trying to monitor the main interface I received ethernet II in the capture and for the backup interface I ...
Hello Everyone !!
I have a question about what normally happens in these 2 cases.
I have a router that uses a Crypto Map on the physical interface and a tunnel configured without encryption.
On another router, I don't have a Crypto Map on the interfa...
Hey everyone,
I was able to schedule a reboot for the device and now is working fine.
One point I noticed is that after the reboot, a new trustpoint certificate was generated, I cannot confirm that this was the problem but now is working fine.
Thank ...
Hello,
I really appreciate the help, I will use the Multi-SA Virtual Tunnel Interface, the configuration applied worked as expected, thank you everyone.
Hello Guys,Thank you for the help.
I'm going this way because I can't configure the Crypto Map on the router because other tunnels will be affected.
But following the configuration already made in the tunnels that are working, this is very strange.
I...
