Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Fellow Colleagues, Is anyone familiar with what the "Default" setting for Rx Sop Threshold represents? This configuration can be found under Wireless > Advanced > Rx Sop Threshold. The other setting options are defined in the help file, but I'm not q...
Fellow colleagues,Where can I find guidance on how to properly configure a single, dual-radio, AP so that the 5GHz is serving clients full time while the XOR radio acts as a full-time sensor? We are using a 3504 WLC and our APs are 2802i. If there is...
Is there a way to display a login banner on the AP CLI? I've tested hoping that the login banner from the WLC would trickle down to the APs, but no dice.
Are all login attempts to the AP's CLI logged anywhere? I did not notice anything relevant fro...
How do interface descriptions work with 802.1x? Will the descriptions remain blank? Will all ports participating in NAC get a generic description? Is it possible to dynamically configure the port description based on the device that is connected to t...
Thanks for the response! I apologize for being unclear, but what I meant was that the other settings (i.e. High, Medium, and Low) have an explicit threshold in dBm associated with each. I am thinking that "Default" could possibly mean one of the foll...
thanks very much for the response. i had actually already configured this, but it didn't seem to work. i discovered that the reason was because of other configurations. in our environment, we only serve clients on 5GHz. to disable 2.4GHz, i navigated...
Hello @Nidhi, Thank you so much for the very detailed article. If I may, I wanted to confirm that I fully understand the solution.1) Are the MDM Flow and Patch Management Flow 2 separate solutions, so I could configure just one or the other? 2) Accor...
Thank you so much for your response!
To add a little bit of context, my organization and I both agree that SSH should be turned off on the AP, but at the same time, want to understand our options as best as possible should the need ever arise.
Below ...
we are on v2.3 patch 3
issuing "application stop ise" results in the following:
Waiting up to 20 seconds for lock: APP_BACKUP APP_BACKUP to completeDatabase is still locked by lock: APP_BACKUP APP_BACKUP. Aborting. Please try it later% Error: Anot...
