Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,My customer would like to provide some extra coverage in a warehouse environment by using what is known in the consumer and SMB market as WDS, Wireless Distribution System. Is this functionality compatible with current WLAN controller and li...
Dear experts,Researching the subject of using a Cisco 2921 router with an RPS 2300, I came across a table in the 2900 Hardware Installation Guide that I can hardly believe: table 5-3 seems to tell me that in order to back up ONE 2921 with RPS powe...
I came across the cab-sfp-50cm cable for interconnection of 3560 switches, but can't find any reference for the support of this cable on 2960 switches. Does the 2960 support this cable or not?Hans
Hi,I need to authenticate all (windows) users who access the internet through an IOS firewall. Applies not only to web traffic (which is easy to do), but also to other applications (e.g. some telebanking programs, RDP sessions etc.)Basically, I need ...
I'd like to use a 1721 router as a 'one-armed' firewall, i.e. routing and firewalling between vlan's on the FE interface of the router. Do the subinterfaces behave any different than physical interfaces for this purpose?
Then let me rephrase my question.After quite a bit of CCO digging, it turns out that the 750W PS can deliver 25A @ 12V, i.e. 300W.The 1150W PS is also limited to 25A @ 12V, it just has more 52V steam.From 2900 info, I find that the 2921 (with AC non-...
Paolo, Thanx for your answer, but I think you missed my point.My only objective here is to provide power backup to ONE Cisco 2921, nothing more.It has its own AC power, so it just needs a backup through the RPS2300.I could decide that a 3925 is a bet...
According to your config, you can't route between VLAN 1 and VLAN 159, because VLAN 1 doesn't have an IP address. Therefore, machines can't see each other across VLANs.
There simply isn't enough space on the front of a WIC for 2 DB-60 connectors, so Cisco came up with the 'SS' (small scale?) connector.Other than that, you could use either WIC-1T or WIC-2T. Make sure you get the right pair of cables one MT and one FC...
Rolf,Use the port in access mode with a voice vlan. When CDP detects a ip phone, the port will operate in a limited trunk mode that allows only 802.1Q tagged frames on the voice vlan. The port still operates mainly as an access port.Hans van der Poel
