Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Folks, I am trying to upgrade a 2960-x using USB, I have formatted the drive to FAT16 and copied the files c2960x-universalk9-mz.152-7.E12.bin and c2960x-universalk9-tar.152-7.E12.tar.However when inserting the USB stick into the switch, I am getting...
Hi,We have an office with two cabinets. One is where our primary switch is located in the basement cabinet and there is a small cabinet on the first floor. Uplink for the first-floor switch is from the basement cabinet switch, and both are Catalyst 9...
Folks, I have been trying to upgrade a list of Catalyst 9200 series switches through DNAC. More than 90% of switches have been successful. But the remaining got failed. Upon checking DNAC, attached is the error reason it is telling.I have rebooted fe...
Hi,I am trying to upgrade a catalyst 9200 to 17.9.7. But stuck with flash space issues. Flash is telling me only 650MB is free. Tried install remove inactive, but no luck.SW01#install remove inactiveinstall_remove: START Fri May 23 10:23:37 BST 2025i...
Hola,We have a 9800-40 WLC wherein more than 150 sites are configured.One of the sites has recently started facing WiFi slowness, and they would like to have a WiFI utilization report for the last one month. Can we download a report of this type from...
@Mark Elsen @Leo Laohoo At this point, I am convinced that its not an issue with the USB stick. Because I have formatted the same stick to FAT32 and upgraded a Catalyst 9200 successfully. So I will try 2960 as well with FAT32 and update you folks. C...
Just checked the logs and the SW1 doesn't have any logs of yesterday. So I lost them as well Spanning Tree - SW1 SW__01#sh spanning-treeVLAN0100Spanning tree enabled protocol rstpRoot ID Priority 32868Address 7488.bbba.0b80This bridge is the rootHel...
