Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have access to WSA CLI and I am searcing any possible deny of traffic based on a specific source IP address: 1. "access_logs" Type: "Access Logs" Retrieval: FTP Poll Do you want this search to be case insensitive? [Y]>Do you want to search f...
Hello, Customer experienced error between a source ip to a destination web site. User said got proxy errors while sending dataIs there a chance to the past logs from Proxy WSA GUI? Thank you
Hello,
I am studying for CCNP switching. I am trying to configure layer 3 channel between two switches in GNS3
Swich_A(Gi0/0-1) -------------------Switch_B(Gi0/0-1)
Po1 - 10.1.20.1/24 Po1 - 10.1.20.2/24
Even...
Hello,
I am studying the CCNP switching and I am trying to set Inter VLAN routing using router-on-a-stick in GNS3
I followed all the commands I need to set to configure this type of topology, but I am getting SVI 2 (Vlan2) down. Where am I wrong?
...
Hello,
Switch_A#show ver
Cisco IOS Software, vios_l2 Software (vios_l2-ADVENTERPRISEK9-M), Version 15.2(4.0.55)E, TEST ENGINEERING ESTG_WEEKLY BUILD, synced to END_OF_FLO_ISP
Switch_B has the same
Thank you
Hello,
Thank you for the answer
I tried to use BPDUFilter:
Root_instance_1#show run int Gi0/2Building configuration...Current configuration : 137 bytes!interface GigabitEthernet0/2 media-type rj45 negotiation auto spanning-tree bpdufilter enabl...
Thanks,
the multiple choice gives the three following answares:
A)Router1 will strip off the source MAC address and replace it with the MAC address 000.0c36.6995
B) Router1 will strip off the destination MAC address and replace it with the MAC addres...
