Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
i have a problem with the merge Conference call in MCU 5310 when the participant already have 9 user in active call,
when the other endpoint want to join to the call it failed to merge.
CUCM 10.5
IM&P 10.5
MCU 5310
the license on the MCU is...
Hi All,
i have a problem when i configure the Transcoder on router 2801, the Maximum Session (0-0)
the router 2801 have the PVDM Card-8, the ios Version is 12.4(22)YB2.
why doesnt have session for the transcoder ?
Below the show and configure :
Ro...
Hi all,
I have a QM Server then, i want to change the IP Address Server.
i trying change the IP Address, and doing restart the service for the SQL and QM(include Jetty),
i also trying restart the server,
then i am doing post install, then change all ...
Hi all,
i have a problem about the VPN pptp client cannot ping to internal network, the router that i use is Cisco 2911
the ip pool client are : 10.0.0.11 10.0.0.254
the ip pptp server : 10.0.0.1
the client can connect to the vpn pptp and browsing to...
Hi Patrick,
how can i check the error?
the MCU that i using is as a media resource on CUCM.
but i join the MCU to CUCM, i using the Sip trunk.
it is posible the problem is on the region?
because the conference between HQ and Sites.
Thanks and Best...
Hi Manish,
Thanks for your help,
for the configure "dspfarm", on this router not have this config.
only have configure dsp services dspfarm
Router(config)#voice-card 0Router(config-voicecard)# ?Voice-card configuration commands: codec ...
Hi Manish,
Thanks for your reply,
i attached the Show running,
on router, it doesn't have the other dspfram.
Please help,
thanks and best regards,
Jonson
Hi Graham,
Thanks for your replay,
after i reinstall the QM (not include the SQL)
the license is already upload to the QM,
but i have a problem, after i finish post install the QM and not have any error,
then i open the web browser QM, the page is j...
