Hello. I am attempting to implement two WAN links into our infrastructure.
We have purchased a 100mbps circuit and a 50 mbps per circuit.
We route between sites using EIGRP and redistribute to BGP for our service provider. They handle BGP to MPLS and...
I am having an issue with an older Cisco ASA running ASDM. I am trying to initiate a Site to Site VPN with a customer who has a Dell SonicWALL. Unfortunately for me, Cisco is not as straight forward when setting up VPN.
Here are the parameters neede...
Hello.I am in the process of replacing a Cisco Catalyst 4506 with a Nexus Solution. We purchased 2 Cisco Nexus 5672UP and are running eVPC with 4 Cisco N2k's as FEX. After configuration of eVPC has successfully formed between the two Nexus 5K's. All ...
I am attempting to for a trunk link between two Cisco switches but trunk is not forming. Both switches are connected via copper (4500x copper to SFP module since 4500X only supports SFP interfaces.). Here is config of both trunking interfaces for bot...
I agree that you should but the global policy does not allow you to customize the ike settings. there are a number of settings listed by priority number. I am unable to customize.
The IKE Policy is greyed out. When i select manage I receive the follwoing message "IKE policy is global. It is shared by all IPSec connection profiles". How can i overcome this?
I have been attemping an L2L vpn setup using the ASDM wizard. The wizard defaults to a seriesof global phase 1 and phase 2 policies. I have a customer with a Dell SonicWALL and they have specific parameters for IKE and IPSec. How can I override the ...
Thank You.Follow up question: Will I have an issue if I have the same SVI configured on both N5ks? How will host connected to either N2k FEX be affected?
Tried setting speed to 1000 but I dont have that option under interface config. 3975-DC-4500X-CSW(config-if)#speed ? nonegotiate Do not negotiate speedI have a copper cable plugged into an SFP converter. Not sure if there is a way to set the interf...
