Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been researching this and unable to find documented info. I've been monitoring some ACLs for a client to see what is/not needed by watching ACL hitcounts. I do have a Primary/Back-up cluster enviorment. What I've found is for example my Prima...
All,I had a problem where my AC operator was experiencing unusual slowness with transfers and parking calls (whether she uses AC or by hand on the phone). I had open a TAC SR and this is was the response:Cisco Unified CallManager System Guide, Relea...
1760 running 12.4(3a)---------------------I had a client that had a hung FXO port (connected to a paging system). The port was at a "S_OPEN_PEND" status when you viewed it 'show voice call summary'Shutting/No Shutting the Voice-Port did not make a d...
All,I am receiving the following error when updating an existing Unity Subsciber:"The new class of serivce,{Default Subscriber}, has insufficient licenses. Reverting to previously saved class of service."I understand I am MAX'd out on my Subsciber Ma...
I am wondering if you are hitting the default timeouts:( •h323 hh:mm:ss is 5 minutes (00:05:00). •half-closed hh:mm:ss is 10 minutes (00:10:00). •icmp hh:mm:ss is 2 minutes (00:00:02) •mgcp hh:mm:ss is 5 minutes (00:05:00). •mgcp-pat hh:mm:ss...
Actually I SSH to the "primary" IP address of the suspected FW, I do a show 'access-list' grepping for the ACL in question.Then I SSH to the "standby" IP (my secondary FW), I do the same 'show access-list' grepping for the ACL in question and this is...
You can setup a phone to dial a specific number (operator/receptionist) as soon as it goes of hook - like "PLAR":1. Create a blank translation pattern,2. Set the Called Party Transformation Mask = the destination number3. Create a special partition ...
I assume you've done the basics swapping out physical phone and/or moving the DN to another phone? If you try all of the above suggestions about dialing the MWI ON/OFF ext..etc. and still does not want to go off... you have this DN listed as a secon...
