hi all I have the following setup:tunnel Port:interface GigabitEthernet1/0/2 switchport access vlan 784 switchport mode dot1q-tunnel switchport nonegotiate l2protocol-tunnel cdp l2protocol-tunnel stp l2protocol-tunnel vtp no cdp enable spanning-tree ...
A quick questionWe want 1gig+ growth upwards in routing throughput with full BGP tables from multiple upstreams.I have been looking at 76XX with dual 720 sups and also the 12XXX series.the 76xx would run SSO/NSF and the 12XXX would also have dual con...
hi allI quick question which I cant seem to find a clear answer for.I was considering implementing stub or totally stub areas in my network, but one area in particular has a small RIP network attached ( this RIP network will not produce a default rou...
I have been looking into object tracking:I can see that it can be used with GLBP,VRRP,HSRP and tracking static routes.Are there any other areas it can be applied to?
HiI would like to see if the following scenario is possible and if so what topics I should be looking at:A remote subnet that is normally connected via leased circuit and IGP.When leased circuit fails I have a DSL which Dials the local ISP.When using...
Hithanks for your responsewe are an ISP and thats why I mentioned the non interface related features, like ISSU etc for carrier grade availability.I will check out those links you sent.
HiYes, but thats not what I meanexample:I have X object being tracked.I can then use the state of that object to influence my HSRP,VRRP, to add a floating route etc etcWhat are other areas/effects that can be altered via tracking the state of an obje...
OKso If I make a 19ft cable and compare it against the standard 50ft cable.the only difference will be the loss etc from the length and connectors.There are no issues with tha cable not being a standard length?
We have the LMR 400 type cable, but its not the type im after its the distance related issue:i.e:Can I make the cable to length or are there specific lengths of cable that have to be met?
