About anhbhph03563

anhbhph03563 · 02-25-2025

Can i configure dspfarm transcode on VCube ?vCuBe#sh inventoryNAME: "Chassis", DESCR: "Cisco Catalyst 8000V Edge Chassis"PID: C8000V , VID: V00 , SN: 94PEYU4VPPHNAME: "module R0", DESCR: "Cisco Catalyst 8000V Edge Route Processor"PID: C8000V , VID: V...

anhbhph03563 · 12-22-2024

Hi Everybody,I want to check the status of phones. I'm using RisPORT70 API, but it checks all clusters and responds with both 'Registered' and 'Unregistered' states. Does anyone know how to collect the 'Registered' status when a phone is registering,...

anhbhph03563 · 03-19-2024

Hi everybody,I want show value of element on activity logs of VXML Application logs.How i can do it?

anhbhph03563 · 02-25-2025

So if I use Cisco Catalyst 8000V (vCUBE), I will not be able to perform transcoding, right?

anhbhph03563 · 02-25-2025

When I don't transcode, the SIP message will respond with a 488 Not Acceptable Media error.I have configured the DSP farm with the hardware CUBE, so it works fine when transcoding is enabled. However, if transcoding is not performed, it doesn't work....

anhbhph03563 · 02-25-2025

Because the ISP is only sending the G711A codec to my SBC, I need to transcode from G711A to G711U.

anhbhph03563 · 02-25-2025

Hi Mohamed,So how can i transcode g711ulaw to other codec on VCube.

anhbhph03563 · 03-19-2024

Thanks you for your information,I tried and it's working.

Member Since	‎03-19-2024 02:59 AM
Date Last Visited	‎04-17-2025 03:30 AM
Posts	8

User Statistics

User Activity

Configure DSPFarm with VCube V8000

Check Status Phone CUCM

Show value of element CVP VXML

Re: Configure DSPFarm with VCube V8000

Re: Configure DSPFarm with VCube V8000

Re: Configure DSPFarm with VCube V8000

Re: Configure DSPFarm with VCube V8000

Re: Show value of element CVP VXML