Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Alexander
In a dual host topology can i put the half of ports over one host (A) and the other half to other host (B), and in case of host fall (A) all the traffic converge to the other host (B).
THANKS
HiI have a 4507re with a power suply data only (1000 watts) if a want to insert a ws-4648-rj45v+e (poe linecard) my question isit will be up? i mean i know that poe will not work, but what about a data? the line card will work like normal non poe...
Hi,I want to configure a UDLD l in link between asr 9000 and ME 3400, but i thint that it is not supported in ASR 9000, then i am configuring ethernet OAM,in two sides.When i disconnected TX fiber of 3400, the asr 9000 sends OAM message and the M...
Sorry i have this: BGP choose the path 3 (output below) how the best path, because the Local Preference, but since this path "is not-in-vrf" the prefix is not in the route table in vrf.sh ip route vrf xxx-xxx 10.1.4.0/22% Network not in tabl...
Sorry about that, ther are two separate asr 9001 (no cluster ) each want have our ip address betwen they will be iccp, i want to use two 10g Link at se same time, in one 10 gig link, traffic of the half 9000v ports, and in the other ...
