Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to configure remote access (IPSEC client) to force all traffic through the tunnel (no split tunnel) yet still limit the internal hosts that can be accessed? I have been asked to provide remote access (via ASA5510) with the following re...
Is it possible to tie Windows AD group membership to authentication for a particular VPN connection profile on PIX/ASA? I am using Windows IAS for RADIUS to authenticate VPN users. I have configured IAS to require that users are a member of the AD gr...
We recently installed MPE 2.1 and would like to use the Outlook plugin to allow users to self-schedule calls. The Cisco documentation (and every posting I can find) says there should be a download link in the lower right corner of the MPE user webpag...
I have found several NetPro postings that indicate CUCM 6.1 will support call monitoring. I have found a few Cisco documents that provide an overview of the technology and provide a diagram. Can anyone point me to any documentation explaining how to ...
Many of my users have complained about the login process for Extension Mobility (we are on Call Manager 3.3(5)). When logging on at the phone, they are prompted to enter User ID and PIN. The UserID is their 4-digit extension. The difficulty is that t...
An edited config for the WAP and the switch are attached. I have removed the password info and some parts of the config that I believe are not relevant (QOS settings, static routes, BGP, OSPF, the configs for switch ports used by other devices).To cl...
We are running Unity 4.0(4.0)SR1.I think the messages are stuck in the Inbox of the Unity Messaging System mailbox. Exchange System manager shows 76 items in this mailbox (and the count never goes down). I have tried to open this mailbox with Outlook...
going back to my original question: if I install a WIC-4ESW (4-port 100mbps) in a 1721, would I get 100mpbs throughput between any of the fast ethernet ports? of just the 6mbps? My client is looking to jump on a 100mbps fiber connect to the internet....
the PIX upgrade to UR would cost over $3000. It would be cheaper to buy another restricted PIX just for the internet connection.am i correct in my understand that the 1721 cannot route packets at 100mbps?
