I read this doc from Cisco and it say that you have to turn off the ip routing on the router (no ip routing):http://www.cisco.com/en/US/tech/tk175/tk15/technologies_configuration_example09186a008071a78c.shtmlI would like to know if is possible to con...
Hello,I'm trying to route the calls made by the extension 18 to a determinated port. For example if the extension 18 dial 0977xxxxx the call have to go to the port 3/1 and the if the extesions 1x dial 0977xxxx have to go to the port 3/0Based on the c...
The last CCME version have h323 and SCCP video compatibility, I would like to know if this CCME feature is compatible with the video MeetingPlace express VT (with h323 ans sccp video protocols).Thank You
Hello,Is there any way to do a transfer consult with the monitored lines on the 7914, without using the global command "transfer-system full-consult dss"? The "transfer-system local-consult" global command is a mandatory.Thank you
Hello,It's possible to configure the Cisco IP Communicator to list the local directory confgured on the CCME 4.0? On 7906 and 7940/60 the local directory is enabled by default but not in the CIPC.Is There any way to change the language on the CIPC?Th...
Hi,The DP pots are over basic digital lines, seems that the "trunk" command on the ephone-dn its only for FXO ports. http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_command_reference_chapter09186a0080611369.html#wp1094625Is it correct?...
Thank you very much for your patience Diego. May be I need to reload the router or change the ip source-address to data vlan (now the ip source-address is the voice vlan addres)I noticed on the attached document that you have the CIPC in italian lan...
Hi,I try to delete the url service line, update de cnf-files and reset the CIPC, but CIPC get it by default. Here is my telephony service config:telephony-service load 7960-7940 P0030702T023 load 7914 S00104000100 load 7905 CP7905080001SCCP051117A lo...
