Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Can we terminate mpls and internet circuit on one DMVPN hub router? Customer is looking for attached high level design.
They have two separate internet circuit and two different layer 2 circuit. They want to terminate two circuit on one hub rout...
Hi,
I have a scenario with two routers, two ASA 5515X and two ISP. I need to configure load balancing so that site to site tunnel traffic should follow ISP 1 and rest of the traffic should follow ISP2 and all the traffic with one either of the ISP in...
Hi, I have two VSS (6509) running in different location, actually two sites they merge. so some of the servers moved from site B to site A but the default gateway is in site A. unfortunately the servers moved they cannot communicate to the default ga...
HiI have this existing QOS configuration in my network.below is the configuration which i gather from access switch and from Core switch.Core Switch=========!mls aging long 64mls aging normal 32mls netflow interfacemls flow ip interface-fullmls nde s...
VSS1 (Pair of 6509)- Site Avtp= ABC / Transparent VSS2 (Pair of 6509) - Site Bvtp= XYZ / Transparent Trunk port between Site A and Site B ==================================================== Site B = SVI vlan 805 = 10.21.5.1/24 Site A = Server = 10.2...
Hi Sandeep,Thanks very much, i found out that one of our engineer he did mistake using the same IP on one of the interface in both the controllers.Regards
