I have replaced ADC Kentrex box with NM-1T3/E3 (the box has failed). After configuring the serial interface, I see the line up and the protocol up but I can't ping Sprint's router as well as they can't ping my router. Sprint is not very helpful becau...

I have setup redundant ISP connections by using SLA and changing routes. I would like to know when SLA rule fails to ping the ISP. I can't find the oid/mib to get the status of the specific SLA or what trap group I need to configure to get notificati...

Hello,I have two sites interconnected by MPLS. Each site has an ASA and is connected to the internet. I'm trying to setup failover for internet connectivity and when on one site the ISP connection is down to route the internet traffic into MPLS and t...

Hi there, I have two sites connected via MPLS network. In each site, ASA is connected to the MPLS router. Each ASA also connected to an ISP via another router. I would like to configure a VPN tunnel between the two sites that will be only used if MPL...

I'm trying to create a subscriber that after leaving the message will not give any options and will disconnect. I managed to remove the Urgent/Regular option but I can't figure out how to remove the prompt to dial extension.Thanks,Hillel.