Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup some privilege restrictions for our NOC group that helps support our WAN circuits on Cisco IOS routers (ex. 4451). This user will only need access to a few commands and the ability to admin down an interface. We use Microsoft RAD...
I am looking for some guidance and/or explanation on how the running config and startup config treat encrypted text on an ASA5505. I have noticed that if you issue a show running config, under aaa-server RADIUS config the key statement has ***** how...
I had some interfaces on an ASR 9906 running ios-xr 6.6.3 that I wanted to default/remove all their configuration and I used the no interface <interface name> command. This has removed the interface completely from the running configuration and now ...
I wanted to get some real world experiences with Netflow setup on remote routers. We have netflow currently configured and working with our Netflow collector but I am reviewing the Netflow setup and thought this would be a good opprotunity to reach ...
We have a couple of hosts in a network where that network will be removed. These hosts are NTP servers so there are many devices setup to talk to the IP Addresses of these NTP servers. The network that the NTP servers are in is an interface vlan on...
Looks like it is related to version. We are running some older code on these ASAs. The ASAs with 9.1(2) display clear text RADIUS key in startup config but the ASAs with 9.1(7) do not display clear text RADIUS key in startup config. We will be replac...
We are looking to do something similar for a few PCs that will have static IPs so I would probably use the method without authentication. However, would there be a way to create a policy that would allow access for updates (ex. Windows Updates, etc....
I used the following links for assistance setting up our phone proxy.https://supportforums.cisco.com/docs/DOC-1364http://angryciscoguy.com/jello/?p=100Hope that helps.
I have tried the suggested above with no luck. My scenario may be a bit different so that is why it is not working. We have a site to site vpn that does not go across the public internet. It is basically going over a layer 2 vlan from site A to s...
