Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, In order to get a usable MTU of 9198, I declare the mtu 9212 on a bundle-ether port (9198+14). The configuration is following : RP/0/RSP0/CPU0:rtr1#sh run int be1interface Bundle-Ether1 mtu 9212 RP/0/RSP0/CPU0:rtr1#sh run int te0/0/0/8interface T...
Hi, I am just about to setup new IOS XR devices (ASR 9901 and NCS 540) and I am encountering a silly problem : when connecting to the devices with SSH from a mac os x client, all the terminal keys are disabled and not recognized (arrow keys, cli comp...
Hi,I am currently deploying some AP541N and I just discovered what seams to be a security bug.The AP541N version : Product Identifier:AP541N-E-K9Hardware Version:V01Software Version:AP541N-K9-1.9(2)I have programmed a SSID with WPA Enterprise standar...
It seams a new firmware was issued on the cisco download site on january 11 :ESW_540_K9_2.1.16.zipI have succesfully downloaded this file, but each time I try to unzip it, I get an error.I have tried to download it several times, using different navi...
I am configuring a 2800 router with a NME-16-1G service module. The service module is in fact a standalone Catalyst 3750 switch and is seen in the router as port gi1/0.I have created a sub interface of gi1/0 in order to get access to vlan 1 on the sw...
So yes, I reproduced the problem on a new router :int be3000mtu 9014int te0/0/0/1bundle id 3000 mode activeint te0/0/0/2bundle id 3000 mode activeresult :be3000 MTU = 9014te0/0/0/1 MTU = 9014te0/0/0/2 MTU = 9014if then I addint be3000.10encapsulation...
Yes, I well know this document and if I add a vlan tag, the header is 18 instead of 14. The problem here is not this one : - I declare a LACP aggregate BE1 with no encapsulation and an MTU of 9014- I put 2 interfaces into this aggregate BE1 without d...
When I connect, I get the following errors :mbagr:.ssh arichard$ ssh root@192.168.240.120Password:Warning: No xauth data; using fake authentication data for X11 forwarding.X11 forwarding request failed on channel 0PTY allocation request failed on cha...
I have a partial solution. On the Wireless/Mac filtering page, the default setup is :MAC Filtering Filter Allow only stations in list Block all stations in list Stations List MAC Address : : : : : Click “Apply...
Yes UC520-8.0.0.zip is avail with IOS 15.0 and CUE 7.1.3, but the localisation files where not updated and can't be installed with version 8.0.When do the localisation files CME-locale-xx-8.0.0.tar and cur-cm-xx-langpack.ise.8.0.0.zip will be avail ?...
