Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a 6513 with Sup720-3BXL. Currently it takes default route from our ISP. The average CPU utilization is 10%. The peak is around 20%. We are thinking to take full route from the ISP. Anyone have experience about this? Thanks a lot.
We have a 6513 with more than 10 IP VLAN interface. We found out the routing between those Vlans doesnt work after we upgrade IOS to Version 12.2(17d)SXB11a. Anyone knows have same experience? Thanks.
We are thinking about to install two 3560s with 1000 Base - ZX SPF to drive a long haul circuit which is about 20 miles. Anyone can give some comments and share some experience about it? Thanks so much.
We have a Gig interface on 6509 showing error traffic information. How to fix it except reboot the box? Thanks.GigabitEthernet4/16 is up, line protocol is up (connected) Hardware is C6k 1000Mb 802.3, address is 0009.11f6.7c87 (bia 0009.11f6.7c87) D...
Once you redistribute the connected route, your route becomes ASBR which mean it sends LSA 7 for the update. It might take a little bit more resource. But I don't see much difference.
Actually I just find out the VLan 10 in blade one can't ping Vlan 20 in blade two. But it can ping Vlan 30 in Blade one. Guess the problem happen only between two Gigabit module.
The host at vlan 10 can ping interface vlan 10 which is in the 6513. But it cant ping the host in vlan 20. I can ping both hosts in vlan 10 and vlan 20 from the switch. Thanks.
