Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All
When connect to SSID, users intermittently gets "Can't connect to this network". Opened a case with TAC and was advised to change EAP timers.But the issue is still happening. Can you have a look and advise based on debug logs?
Thanks in advans...
Hi all,
Can you help me to understand that, how the packets are processed in ASA 8.4 and later ?
that is the order of packet processing happened .
( something similar like the below of paloalto traffic flow :
Thank you.
Mithun R
Hi Team,I have a requirement to do vlan bridging. That is My core switch has vlan 101, which connects to the MPLS router. And users from branch officer reach HQ via MPLS -> Core Switch.And server segments-1 is located under vlan 105. ans server segme...
Hi All,I need your help to understand about 6500 series supported USB drives and or USB drive formats.Recently I tried to copy the firmware image for SUP-8E from USB for C6507R+E VSS Switch. But when I check the directory usb0:, no usb were detected...
Hi all,
We are planning to purchase ASA 5516-x with firepower service appliances. We are considering email security feature as well.
I really don't have clear idea on the Cloud based email security license (L-S-CES-ESI-LIC=) ?
Is it to be installed...
Hi Marce
Thanks for the help and reply. Will try above suggestions
Controller model = 2504 (AIR-CT2504-K9) version = 8.3.143.0
Issue happens even when the users are on desk ( not moving).
I noticed from debug logs that, client is stuck at connecting ...
Hi zheepern,As I understand, your voice gateway should send the traffic to R2 ? if so assing a different vlan on switch for the voice network and connect the voice gateway & the voice router...configure the tcp/ip gateway of voice gateway as your voi...
EIGRP uses Bandwidth and Delay For Accurate cost calculation and efficient route selection. you must use 200,000 kbps for ISP1 and 4,000,000.
Just in curious, why do you want to run EIGRP on Untrust networks ?