Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Telepresence IX5000 unit that is missing a few items to complete:800-42131-xx (Trim Under Monitors 3 pieces)74-13021-xx (Front Bottom Main Covers 3 pieces)74-12905-xx (Front Top Main Covers 3 pieces)800-41842-xx (Vertical Bezels between Moni...
I am needing a little help converting these rules from a 5510 to a 5520 running 9.1:
global (outside) 1 10.10.50.11-10.10.50.249 netmask 255.255.255.0
nat (inside) 0 access-list NONATnat (inside) 1 10.0.0.0 255.0.0.0
static (inside,outside) 10.10.50...
I need to NAT or PAT, a couple inside hosts to the outside interface. Problem is I don't want to create a NAT pool for the couple inside hosts to NAT to.
Need some advice/help on a firewall issue. Not sure this is the forum I should be in, but anyhow this is the issue: I got a Linux box hosting Nagios that is on the inside interface of a Cisco ASA5510. The Windows boxes I monitor are on the outside in...
Hello,
I am having an issue with setting up the Cisco Small Business SG300 switches on active directory. I have not had no problems with our 2960's or above switches, just the SG type switches. I have been trying to setup the SG series switches thro...
Let me be more specific to my situation...
inside: 10.5.x.x /16
outside: 10.30.x.x /24
Inside Hosts: 10.5.x.x /16 and 10.5.x.x /16
I need the inside hosts to NAT to the outside Address 10.30.x.x
(This will be the only outbound traffic and there wi...
Right, so I want to translate two inside hosts to the outside interface ip. Than I can create ACLs to control the traffic. I am leaning on NAT Overload or Port Forwarding I believe... First time configuring...
