Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, a "hair pulling" problem. Has one site of many using Flexconnected LAPs, where Windows 10 clients are having extremely slow net access via LAP3602. But as a test we did try a LAP3702 and voila the net worked OK. Any tips at all will be helpfull ...
Hi, next week I am going to a customer and upgrade his wireless installation. From a WISM / WCS system to a WISM2 / Cisco Prime Infrastructure system. Does anyone have any best practice advice in such scenarios? Exchange the WISM with the WISM2 first...
Hi, is there a way to get the same info as listed by the IOS command: show dot11 associationsusing snmp under Linux? The closest I have found is: snmpwalk -v1 -c public 172.24.24.218 | grep RFC1213-MIB::atPhysAddressAnyone?
Hi, I'm graphing network traffic using MRTG. The graph showing the traffic on an physical interface (ie. int fa0/1) in the Catalyst 3550 shows up OK. But when I try to graph the traffic on an VLAN interface (ie. int vlan 3), the graph only shows some...
I have a installation with exact the same problem, upgraded the 4400 controller to firmware version 4.1.171.0 - but that made no difference. The log from the switch that the lwapps is connected to shows no indication of link up/down events. So any ne...
I have observed the same problem, and I did disable the IDS signature 4050:ip audit signature 4050 disableAnd also check that you have the:isakmp nat-traversal 20
All the VLANs seems to have near to no traffic at all at all times, when graphed using MRTG. But the graph for the physical interface is "correct". And I know that one of the VLANs carry a lot of traffic.
Hm, I have browsed through the 12.1(13)EA1 release notes, and the only command regarding PBR seems to be "debug pbr"??? Could you please give me some examples on how to configure pbr in this new IOS release?
