About nsuchak

nsuchak · 04-14-2004

Hello I have Unity 4.0(3) with E2k off box running. We can not seem to find a way of enabling the MWI lamp to be lit when we recieve a read recipt. Is this a setting that can be changed ?When we go into the mailbox to check the message is there. MWI...

nsuchak · 02-27-2004

Hey Azam couple of points to note in the trace file. The called party number you are sending is 9123 to the PSTN make sure that you are stripping the 9 at the route pattern. I assume you are calling the speaking clock ? Also the telco has not provisi...

nsuchak · 02-16-2004

Best palce to start is the CCM trace's. Let the ip phone register with a CCM node. Once it has registered open the ccm trace, (ensure you have set the trace level to arbitarty, via servicability)Then search for the MAC addr of the phone in the trace...

Re: User Fast Dials & Address Books · 02-16-2004

The information is stored in the ldap directory, normally DC if you use the ccm integrated directory. You can open DC directory admin or your ldap admin tool and browse down the tree. All fastdial and PAB info is stored in the directory.If you have ...

nsuchak · 02-16-2004

Take a look in you callmanager debugs to see why the routelist is exhausted. Normally this is becasue the gateways in the associatted group are either down or you have run out of gateways.Look at the ccm trace on the node that sent the message aeoun...

Member Since	‎10-14-2003 12:16 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	7

User Statistics

User Activity

MWI notifcation on delivery of read recipts....

Re: MGCP - Call setup problem

Re: IP Phone register but no dial tone

Re: User Fast Dials & Address Books

Re: CalManager SNMP RouteList Exhaust traps