Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi forum,Does anyone know if it's possible to run UC500 as an SRST gw on remote site controlled by a central CCM?I have to start a deployment on some offices and I wonder I would start with UC500 boxes (good price & all-in-one box) or with ISR router...
Hi, I wish to connect LWAPP AP on a remote office. The controler will be reachable through on OSPF L3 network. Moreover, I wish to define my WLAN VLAN on the remote office so as the WLAN client have a remote IP and are switched by the remote switch.A...
Dear Forum,Does anybody knows if it is possible to manage several differents configurations release for a single device (PIX) through FMC 1.3.2 without the workflow function enabled (ie workflow disabled !)If yes, how to ???Many thanks
Dear forum,I try to manage a very big PIX configuration (about 1000 acls) from FMC 1.3 but I experience really poor performance and in particular due to java interface.Does anybody knows how to customize FMC to speed up java or to optimize the vario...
Dear support,My PIX asks AAA for HTTP traffic. The timeout are set up as 1hour for absolute and 20 minutes for inactivity.Everything was working correctly in PIX 6.2(2).I've upgraded the pix to 6.3(3). Now, an authentication request is asking at each...
Yes, that's it.It seems to have many limitation as it's WAN-like architecture. However, in my case, OSPF links between AP and WLAN controler are Gbps optical links! so I guess it will be performant..I wish to pass Voice and DATA packets through this ...
Hi,it seems that failover link and statefull failover link can be configured on the same physical interface but whithout the need of configuring vlan.Does anyone can confirm my experience ?
Hello,you say that the easiest way to solve this problem is to enable the IPSec over UDP. Once the option is checked in the VPN client configuration, is there any parameter to add in the PIX configuration ?Thanks
