Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Need help to understanding why my pxgrid is not working between Catalyst Center and ISE.Username and password are correct, same with Shared SecretSee the picture
Right now I have a mixed environment with 2960, 1000 series and 9200 switches (I will replace all 2960).When I add the switches to Catalyst Center, the 1000 series is listed as a Third Party Device. Why?It is only cosmetic but annoying..If you click ...
HiI have two WLC 9800 in HA.Active WLC is in server room A Standby WLC is in server room B.RP is connected with direct fiber.Link ports are connected to 9500 switch (one in server room A and one in server room B) between the switches I have a trunk t...
Hi,I am running ISE 3.4 Patch 4.I have a Computer that is managed in Entra and the computer is in a group called "EntraID-Test-Group".I have a connection between ISE and Entra ID (External Identity Sources - > Rest). There I can also choose which gro...
Thanks for your answer.This was just an example. The real problem is this:"vSphere HA has triggered a “Host Isolation IP not available” warning for esxi123 because it failed to ping the isolation address 172.22.2.1"It doesn't happen all the time, but...
I think you Radius config is wrong.Test this.!dot1x system-auth-control!aaa new-model!!aaa group server radius SRV-RADIUS server name RADIUS-SRV!!radius server RADIUS-SRV address ipv4 10.1.29.2 auth-port 1812 acct-port 1813 key 7 xxx!aaa authenticati...
Provision > Inventory, select your switch, and click Actions > Software Images > Update Image. Select the image that was already distributed.Re-activation: In the workflow, ensure you do not select "skip activation" again.
