Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello can the 5508-12 be converted into a standby HA controller? Cisco is abiguously saying that 50 permanent licenses are needed on a standby controller.Does it mean we need 50 base licences (so only 5508-50 and above) or 50 licenses as any combinat...
Hi guys, see the attached diagram for these question:What routers will receive udpates originated on the routers below supposing each node has default BGP configurations (and no sync enabled)?Route originated on ARoute originated on CRoute originated...
Hi guys,We want to connect one of the CE routers to two our PE's (active/standby, no loadbalancing) and use dynamic protocol for route exchange.Both PE's and CE share the same subnet.What are our options? Can we use HSRP, make one PE active and align...
Hi, my F132 is running at 230Gbps in 7009 and 5x FAB2. Why is this F1 card running at this speed and M2 card is at full 550Gbps?Datasheets of both cards give their max BW lower than 550Gbps. After all, maybe the question should rather be why the M2 i...
Hi, Cisco docs state all F3 modules support FEX connections. How can F3 module with 100G CPAK interfaces support FEX? Also the same with one M2 and its 100G CFP interfaces.. 40G QSFP+ interfaces have breakout cable to 4x10G LC, is there something sim...
Jon,I have one seemingly interesting point here, when the active's PE interface to core goes down then the CE's weight will be still active pointing to this now faulty PE, until tables are flushed on PE. Is this correct?And yes returning traffic shou...
Jon,1) BGP is used for PE-CE route exchange2) Yes we have full control of PE3) PE run iBGP between them via MPLS coreAny suggestion of what is the best way to achieve desired active/standby PE is welcome. Whether it involves HSRP or not is not a big ...
Hi James,Thank you. So the summary:F3 100G CPAK module support FEX modules using breakout cables.M2 100G CFP module does not support FEX per its datasheet.
Leo, thanks for the link, marked as correct.To add I used this table for my comparison: http://www.cisco.com/en/US/products/ps9402/prod_models_comparison.html#~tab-b .There M224 is 240Gbps and F132 used to have 230Gbps. Interestingly that FAB2 enable...
